calculate-loan

01 Loan payments

Declining Balance Method: Formula & How to Use It

Calculator No. 01-21589 · Updated · Formula and assumptions shown below

The calculator on this page is switched off while it is checked. The formula is below, and the worked example shows how to do the sum by hand.

Estimate for education, not financial advice. The result follows from the numbers you enter and the formula shown. It is not a quote or an offer, and it does not include fees, taxes or insurance unless the calculator asks for them. Ask your lender for the exact figures.

The declining balance method calculates depreciation by applying a fixed percentage rate to the asset’s book value at the start of each year, producing larger expenses in early years and smaller ones later. To use it, you need the asset’s cost, its salvage value, its useful life, and a depreciation rate (often double the straight-line rate). The formula is: Depreciation Expense = Book Value at Beginning of Year × Depreciation Rate, where Book Value = Cost − Accumulated Depreciation.

Formula

The declining balance method is expressed as:

Depreciation Expense = Book Value at Beginning of Year × Rate

Where:

  • Book Value at Beginning of Year = original cost minus accumulated depreciation from all prior years (in $).
  • Rate = the annual depreciation rate, expressed as a decimal (e.g., 40% = 0.40). This rate is often a multiple of the straight-line rate, such as 200% (double-declining) or 150%.

The straight-line rate is simply 1 ÷ useful life. For a 5-year asset, the straight-line rate is 20%. Double-declining uses 2 × 20% = 40%. The formula assumes you apply the rate to the remaining book value each year, not to the original cost.

Worked Example

Using the calculator’s default values: cost = $10,000, salvage = $1,000, useful life = 5 years, rate = 40% (double-declining).

  1. Year 1: Book value = $10,000. Depreciation = $10,000 × 0.40 = $4,000. Book value at end of year = $10,000 − $4,000 = $6,000.
  2. Year 2: Depreciation = $6,000 × 0.40 = $2,400. Book value = $6,000 − $2,400 = $3,600.
  3. Year 3: Depreciation = $3,600 × 0.40 = $1,440. Book value = $3,600 − $1,440 = $2,160.
  4. Year 4: Depreciation = $2,160 × 0.40 = $864. Book value = $2,160 − $864 = $1,296.
  5. Year 5: Without a salvage constraint, depreciation would be $1,296 × 0.40 = $518.40, leaving book value $777.60. But salvage value is $1,000, so you must stop depreciating once book value reaches salvage. In year 5, you only depreciate $296 (from $1,296 down to $1,000).

The calculator’s first output shows Year 1 depreciation = $4,000 and book value after year 1 = $6,000, matching the step above. Note that the calculator does not automatically stop at salvage value; you must manually adjust in the final year, as shown in the example.

Assumptions

  • The depreciation rate is constant each year.
  • Depreciation is calculated on the book value at the start of the year (not mid-year, unless you specify a convention).
  • Salvage value is an estimate of what the asset will be worth at the end of its useful life; you should not depreciate below that value.
  • This method does not account for taxes, inflation, or any changes in the asset’s market value.

Why Use the Declining Balance Method?

Businesses choose this method when an asset loses value faster in its early years. Examples include vehicles, computers, and machinery that become obsolete quickly. The logic is that the asset provides more utility (and generates more revenue) when it is new, so matching a higher depreciation expense to those earlier years is more accurate from an accounting standpoint. It also reduces taxable income more in early years, which can be beneficial for cash flow, but that depends on tax rules, which vary by jurisdiction.

How to Choose the Depreciation Rate

The rate is not arbitrary. Common multiples are:

  • 200% (Double-Declining Balance): rate = 2 × (1 / useful life). Used for assets that lose value very quickly, like electronics.
  • 150%: rate = 1.5 × (1 / useful life). A more moderate acceleration, sometimes used for longer-lived assets.
  • 125%: rate = 1.25 × (1 / useful life). Even milder.

You can also choose a rate that is not a simple multiple, but the multiple approach is standard because it ties the rate to the asset’s estimated useful life. The higher the multiple, the faster the write-off and the lower the book value in early years.

Common Mistakes and Misconceptions

  • Applying the rate to original cost every year: That would be straight-line, not declining balance. The rate always applies to the remaining book value.
  • Ignoring salvage value: If you keep applying the rate, book value will approach zero but never reach it. You must stop at salvage value, which often means the last year’s depreciation is a smaller “catch-up” amount.
  • Using the rate as a percentage without converting: Always convert the percentage to a decimal (40% = 0.40) in the formula.
  • Forgetting mid-year conventions: The formula assumes a full year of depreciation. If you buy an asset mid-year, you prorate the first year’s depreciation by the fraction of the year it was in service.

Comparison with Other Methods

  • Straight-Line: Equal expense each year. Simpler, but does not reflect rapid early decline.
  • Sum-of-the-Years’-Digits: Accelerated, but uses a decreasing fraction based on the sum of the years’ digits. The expense pattern is similar to declining balance but the math is different.
  • Units of Production: Depreciation based on actual usage (e.g., miles driven, hours used). More accurate for assets that wear out from use, not time.

Declining balance is best when you want a simple, consistent acceleration. It is widely used in financial reporting and tax (where allowed).

Limitations and Practical Notes

The declining balance method can overstate depreciation in early years if the asset does not actually lose value that fast. It also never fully depreciates to zero unless you force a switch to straight-line in the later years (a common practice: switch when straight-line depreciation on the remaining book value exceeds the declining balance amount). The method is also sensitive to the chosen rate; a small change in rate can significantly affect early-year expenses. Always check your accounting standards (e.g., GAAP or IFRS) for acceptable methods and rates.

Frequently Asked Questions

What is the difference between declining balance and double-declining balance?

Double-declining balance is a specific type of declining balance where the rate is twice the straight-line rate. For a 5-year asset, straight-line is 20%, so double-declining uses 40%. Declining balance can use any multiple (150%, 200%, etc.), so double-declining is just the 200% version.

Can I use declining balance for tax purposes?

Many tax systems allow accelerated depreciation, but the exact rules vary. For example, the U.S. MACRS system uses declining balance methods (200% or 150%) for certain assets. However, tax rules often have specific conventions (half-year, mid-quarter) and recovery periods. This calculator gives a general estimate; consult your tax authority or accountant for your specific situation.

What happens if the book value goes below salvage value?

You should not let that happen. The purpose of salvage value is to set a floor. In the final year, you adjust the depreciation to exactly bring book value down to salvage. If your calculated depreciation would push book value below salvage, you only depreciate the difference.

How do I handle partial-year depreciation?

If you acquire the asset partway through the year, you prorate the first year’s depreciation. For example, if you buy an asset in July (6 months left in the year), you take half of the annual depreciation in the first year. The remaining years are full years, and the final year may have a partial amount as well.

Why does the book value never reach zero with this method?

Because the depreciation is a fixed percentage of the remaining balance, the balance decreases geometrically. Mathematically, it approaches zero but never quite reaches it. That is why salvage value is essential and why many switch to straight-line in the later years to fully depreciate the asset.

This calculator provides an estimate of depreciation for educational purposes. The exact figures in your financial statements depend on your accounting policies and applicable regulations; always refer to your accountant or the relevant standards.

Related

Formula used
in p | Asset cost | $ | 10000 | 1 | 10000000
in sv | Salvage value | $ | 1000 | 0 | 10000000
in yrs | Useful life | years | 5 | 1 | 50
in rate | Depreciation rate (as %) | % | 40 | 0.01 | 100
out dep | Year 1 depreciation | $ | p * (rate / 100) | 2
out bv | Book value after year 1 | $ | p - dep | 2

Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work

Method: the standard loan formula for this calculation, fixed rate and monthly compounding unless stated, rounded as each result states. Not financial advice; no lender, rate or product is recommended. See formulas and assumptions, the disclaimer or report an error.

More in this section

The whole Loan payments section →